Nureva Console client
Yes, the HDL300 works with the Lifesize Icon 600 conference room solution.
To get started, first check that the HDL300 is up-to-date and set up correctly:
Creating custom cables
Prepare two 3.5 mm jack cables with the three pins positive (+), negative (–) and ground (G) per Nureva auxiliary port recommendations. Label one Cable 1 and the other Cable 2.
See the article What kind of auxiliary jacks are compatible with the HDL300 system? for more information.
On the HDL300 connect module
On the Lifesize Icon 600 CODEC
To start a video conferencing call, see the article Does the HDL300 system work with audio conferencing (UC&C) software? for more information on setting up and using the LifeSize UC&C client.
Connection Diagram
NOTE: The Nureva Aux In / Out connections are single-ended, unbalanced signals with default maximum output signals as given in the table below. Any equipment requiring voltages below these levels may result in clipping, distortion and, in extreme cases, damage to connected systems. Equipment requiring voltages above these levels will not be adequately driven by the HDL300 system’s output signal and may result in quiet / no audio on the channel. Before connecting to the Nureva Connect Module, make sure the third-party device voltage levels are adequate or adjusted properly by additional interfacing hardware.
Last updated: February 26, 2021