Nureva has determined that the WolfVision Cynap will work with the following Nureva products when configured as shown in this article.
- HDL200 audio conferencing system
- HDL300 audio conferencing system
- Dual HDL300 audio conferencing system
- CV30 camera kit
Please visit WolfVision.com for more information about the Cynap and other WolfVision products.
To get started, choose the tab for the Nureva audio device to be integrated.
HDL200 system
On the HDL200
- Plug in the 54VDC power supply to the back of the HDL200
- Connect a laptop to the HDL200 using the provided USB-A to USB-B cable
- Download and run Nureva Console client
- Complete the setup of your HDL200 by following the on-screen instructions
- Choose System information
- Select Check for firmware update
- Install available updates
- Recalibrate the system for the best HDL200 experience
- Exit Nureva Console client and disconnect the HDL200 system from your laptop
On the WolfVision Cynap device
- Connect the HDL200 system to the USB-A 3.0 port on the Cynap
- Complete the required connections (power supply, HDMI for display, Ethernet, etc.)
- Connect any additional equipment (e.g. CV30 camera, keyboard/mouse, etc.)
- Power on the device
Configuring for the first time
- In the Cynap interface, open the system settings and log in as an administrator
- Select the Audio section
- Set the following settings:
- Echo Cancellation = OFF
- USB MIC ENABLE = ON
- PREFERRED USB MIC = HDL200
- WEV CONFERENCE OUTPUT = ON
- LOCAL OUTPUT = OFF
- USB SPEAKER ENABLE = ON (Ensure HDL200 selected below)
- SPLIT WEB CONFERENCE TO USB SPEAKER = ON
- Close the system settings menu and restart the Cynap device
- Launch your preferred UC&C application and confirm the functionality
Connection diagram
HDL300 and Dual HDL300 systems
On the HDL300
- Connect the PoE cable (provided) to the RJ45-1 port on the connect module to the rear port on the HDL300 system
- Plug in the 54VDC power supply on the connect module
- Connect a laptop to the connect module using the provided USB-A to USB-B cable
- Download and run
On the WolfVision Cynap device
- Connect the HDL300 system to the USB-A 3.0 port on the Cynap
- Complete the required connections (power supply, HDMI for display, Ethernet, etc.)
- Connect any additional equipment (e.g. CV30 camera, keyboard/mouse, etc.)
- Power on the device
Configure for the first time
- In the Cynap interface, open the system settings and log in as an administrator
- Audio section
- Set the following settings:
- Echo Cancellation = OFF
- USB MIC ENABLE = ON
- PREFERRED USB MIC = HDL300
- WEV CONFERENCE OUTPUT = ON
- LOCAL OUTPUT = OFF
- USB SPEAKER ENABLE = ON (Ensure HDL300 selected below)
- SPLIT WEB CONFERENCE TO USB SPEAKER = ON
Connection diagram
NOTE: The technical information provided in this article, including specifications and recommendations, is provided for customer convenience. The accuracy of this information is not guaranteed and is subject to change without notice. Please check the user manuals and related documentation from each product manufacturer to ensure that your setup meets the proper recommendations.