Is the HDL300 system compatible with the StarLeaf Telepresence GT Mini 3330?

Nureva® Console client with Windows® 10 operating system
Last Updated: August 16th, 2021

Yes, the HDL300 audio conferencing system will work with the StarLeaf Telepresence GT 3330 codec using the following steps:

To get started, first check that the HDL300 is up-to-date and set up correctly:

On the Connect Module and PC

  1. Connect a USB-A to USB-B cable from your laptop to the Connect Module
  2. Download and run Nureva Console client 
  3. Register the HDL300 system following the on-screen instructions
  4. In Nureva Concole client
    1. From the left-hand menu, select System Information
    2. If a firmware update is available, click on Update
    3. From the left-hand menu, choose Device settings
      1. Auxiliary ports
        1. Change to Mic level
        2. Ensure Sleep Mode is set to OFF
  5. Disconnect the connect module from your laptop and remove the USB cable.
  6. Connect the PoE cable (provided) to the RJ45-1 port on the connect module to the rear port on the HDL300 system
  7. Plug in the 54VDC power supply

StarLeaf GT 3330 settings

Using your Admin account in the StarLeaf web portal, login and select Edit room system → Audio & Video settings 

Line In

  1. Set "Device" to Line In
  2. Set "Gain" slider between the range of -2dB to 4dB, depending on your room configuration and the audio experience
  3. Under ECAN options, uncheck the "Disable echo cancellation"

Line Out

  1. Set "Device" to Line Out
  2. Set the "Gain" slider to 0 dB
  3. Click 'Apply' and 'Ok' to exit the screen



NOTE: The Nureva Aux In / Out connections are single-ended, unbalanced signals with default maximum output signals as given in the table below. Any equipment requiring voltages below these levels may result in clipping, distortion, and, in extreme cases, damage to connected systems. Equipment requiring voltages above these levels will not be adequately driven by the HDL300 system’s output signal and may result in quiet / no audio on the channel. 

Before connecting to the Connect Module ports, make sure the CODEC provided-voltage levels are adequate or adjusted properly by additional interfacing hardware. 


Was this article helpful?

Can’t find what you’re looking for?

Contact Support

1.844.370.2111