Follow the steps below to install and use the Table stand for the HDL200 system.

Step 1:  Remove the Table stand pieces from the sleeve

NOTE: The stand pieces are interchangeable.

Step 2:  Locate the mounting locations

Step 3:  Insert tab on each Table stand piece into the mounting location.

 Step 4:  Position the HDL200 system and complete connecting the system to the in-room PC.

IMPORTANT: Do not block the vents on the top, bottom, or back surface of the unit. These vents are required to keep the circuits from overheating.  Failure to do so may cause the unit to fail or malfunction.