Yes, the HDL300 audio conferencing system will work with the Polycom EagleEye Director II camera tracking device using the following steps:
On the HDL300 system connect module
Setting up the Polycom EagleEye
Enabling the Polycom camera
Polycom's camera uses tracking filtering to identify and ignore far-end audio. To properly enable this setting, specific Windows® audio settings are required on the in-room PC:
The PolyCom EagleEye Director II technology will now identify the audio-feed from the remote participants, which is playing back through the HDL300 and selectively avoid camera-tracking this source.
NOTE: All UC&C clients must have the HDL300 set as the Microphone input Audio output and the Speaker Output set to the PC internal audio card (Speakers/headphones).
NOTE: The Nureva Aux In / Out connections are single-ended, unbalanced signals with default maximum output signals as given in the table below. Any equipment requiring voltages below these levels may result in clipping, distortion and, in extreme cases, damage to connected systems. Equipment requiring voltages above these levels will not be adequately driven by the HDL300 system’s output signal and may result in quiet / no audio on the channel. Before connecting to the Nureva Connect Module, make sure the third-party device voltage levels are adequate or adjusted properly by additional interfacing hardware.
Last updated: January 14, 2020