Yes. To connect the HDL300 system with the Extron DMP ProDSP™ 64 Digital Matrix Processor, two custom cables are needed to accommodate the standard 3.5 mm jack connector on the HDL300 system's Connect Module with the standard Euroblock connectors on the Extron I/O panel.
Creating custom cables
Cable 1: Prepare a 3.5 mm jack cable with the three pins, positive (+), negative (–) and ground (), wired to an appropriate Euroblock 3-conductor terminal block as described in the Extron DMP user manual.
Cable 2: Prepare a second 3.5 mm jack cable with the three pins, positive (+), negative (–) and ground (), wired to accommodate an appropriate Euroblock 3-conductor terminal block as described in the Extron DMP user manual.
Nureva Room Manager
On the connect module
On the Extron processor
NOTE: The Nureva Aux In / Out connections are single-ended, unbalanced signals with default maximum output signals as given in the table below. Any equipment requiring voltages below these levels may result in clipping, distortion and, in extreme cases, damage to connected systems. Equipment requiring voltages above these levels will not be adequately driven by the HDL300 system’s output signal and may result in quiet / no audio on the channel. Before connecting to the Nureva Connect Module, make sure the third-party device voltage levels are adequate or adjusted properly by additional interfacing hardware.
Last updated: January 14, 2020