Popular topics: Downloads Can I connect my computer wirelessly to the projector? HDL300 system installation guide Download Room Manager Room Manager features overview ► WM408i installation guide and drawings ► HDL300 system integration guide More download options Microphone clearance requirements and recommendations Does the HDL300 system work with audio conferencing (UC&C) software? Installation guides and drawings Using the auxiliary ports on the HDL300 system Span Workspace technical requirements HDL300 and Dual HDL300 system connection diagrams Getting started with your HDL300 system Installing a Dual HDL300 system Is the HDL300 system compatible with the Cisco® SX80? Setting up Jira® for Span Workspace ► Copying and pasting onto the canvas WM210i and WM307i technical requirements

What is the IP range for the image alignment module and can it be customized?

The Nureva image alignment module NAM2-1 and NAM1-1's IP range can only be customized within the range of 198.168.0.2 to 198.168.0.255. 

The factory settings are

NAM1-1: 198.168.0.11
NAM2-1: Channel A 198.168.0.11 Channel B 198.168.0.12


Changing the IP address

  1. Locate the dials on the back of the unit. There are three dials on the NAM1-1 and six on the NAM2-1. Each dial corresponds with one of the last three digits of the IP address.
For the NAM2-1, the top row of dials corresponds with the IP address for Channel A and the bottom row corresponds with Channel B. 
  1. Use a small flat head screw driver to set the new IP address for each channel.
  2. Power off the unit, wait ten seconds, then power back on.
  3. Open the Span setup center by tapping the icon in your task bar
  4. Tap Image Alignment
  5. Tap Settings 
  6. Compare the IP addresses in the Span setup center with the ones programmed into the back of the unit. If the IP addresses do not match, change the ones in the Span setup center to match the NAM2-1.



Last updated: February 20, 2017

Was this article helpful?

Can’t find what you’re looking for?

Contact Support

1.844.370.2111