Popular topics: Downloads HDL300 system installation guide Download Room Manager Can I connect my computer wirelessly to the projector? Room Manager features overview ► WM408i installation guide and drawings ► More download options HDL300 system integration guide Installation guides and drawings Enabling QuickShare on your canvas ► Using the auxiliary ports Does the HDL300 system work with audio conferencing (UC&C) software? Span Workspace technical requirements System connection diagram Setting up SSO (single sign-on) WM210i and WM307i technical requirements Is the HDL300 system compatible with the Cisco® SX80? Screen share troubleshooting Adding a bookmark to your mobile home screen ► On-screen image alignment and touch calibration

Trimming your WhisperTek™ surface

Your WhisperTek surface can be trimmed down to size with a few simple tools:

    Retractable utility knife with a fresh blade

    48" (120 m) long standard drywall T-square

    Hard surface  – such as a milled and planed flat board

    10 cm wide painter's tape – or masking tape

    Work gloves

    Pen


Trimming your WhisperTek surface

  1. Lay the WhisperTek surface on a hard surface on the floor. The hard surface will protect the floor from the knife blade.
  2. Mark the cutline at 86" (2.18m)
  1. Align the T-square to the cutline. You can tape the left edge of the T-square to keep it from moving.
  1. Drag the knife edge along the full length of the cutline to score the surface. Do not press too hard on your first cut.
  2. Repeat the cut 2–3 times until the knife blade cuts through the WisperTek surface into the hardboard

For new WM307i installs, order the WhisperTek HD surface.



Last updated: September 5, 2017

Was this article helpful?

Can’t find what you’re looking for?

Contact Support

1.844.370.2111